Add Modify or Delete a Source NAT (SNAT) rule and a Destination NAT (DNAT) rule

 

Source Nat (SNAT) Rule

 
Step 1. Double click on the Edge Services Gateway (ESG) that you would like to configure NAT on.
 
1
 
Step 2. Select Manage -> NAT then click the + sign and select Add SNAT Rule
 
2E
 
Step 3. Specify the External Interface, Original Source IP/Range, and Translated IP/Range, a Description, and Logging (optional) Make sure you select the checkbox Enabled then click OK
 
Note: You can specify a single IP(x.x.x.x), an IP Range (x.x.x.x-x.x.x.x) or a Subnet (x.x.x.x/24)
 
3
 
Step 4. Click Publish Changes
 

Destination Nat (DNAT) Rule

 
Step 5. Select Manage -> NAT then click the + sign and select Add DNAT Rule
 
4
 
Step 6. Specify the External Interface, Original IP/Range, Port Range, and Translated IP/Range and Port Range, a Description, and Logging (optional) Make sure you select the checkbox Enabled then click OK
 
Note: You can specify a single IP(x.x.x.x), an IP Range (x.x.x.x-x.x.x.x) or a Subnet (x.x.x.x/24)
 
5
 
Step 7. Click Publish Changes
 

Leave A Comment

Your email address will not be published. Required fields are marked (required):

Back to Top