Deploy vShield Endpoints

 
vShield Endpoints installs a new VIB and service VM on every host in the cluster. It is a prerequisite for Data Security, Activity Monitoring, and third party vendors like Palo Alto firewalls and TrendMicro.
 
Step 1. Log into the vSphere Web Client and navigate to Networking & Security -> Installation -> Service Deployments
 
1
 
Step 2. Click the + icon and select Guest Introspection and click Next. Note: In previous versions it is called vShield Endpoint.
 
1
 
Step 3. Select the Datacenter and Cluster then click Next
 
2
 
Step 4. Select the Datastore, Network, and IP assignment then hit Next
 
3
 
Step 5. Confirm your settings, then click Finish
 
4
 

2 Comments

  1. mokhtar -  May 21, 2015 - 6:47 am 108

    NSX_Series :
    trunk port use for L2VPN on NSX
    please can you help me to understand this point , why here in trunk
    interface i will need to associate it with port_group meaning this
    trunk port when you associate it
    with port group you will assign it in one vlan ,

    i think during creation of DVS port_group that you will attach your
    link in it you left it as non vlan please confirm or allow all vlans ?

    Reply
    • Sean Whitney -  May 21, 2015 - 10:04 am 111

      Hi Mokhtar, was this comment specific to a different post? Can you link to the document you are referencing, I apologize but I don’t think I am understanding the question.

      Thanks,
      Sean

      Reply

Leave A Comment

Your email address will not be published. Required fields are marked (required):

Back to Top